Mambuat VLAN Di Aplikasi Cysco

Cara Setting Vlan Menggunakan Cisco

Berikut Cara untuk setting jaringan seperti diatas

- Cara membuat vlan 101 dan 102 di Switch

Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface fa 0/2
Switch(config-if)#switchport
Switch(config-if)#switchport mode access
Switch(config-if)#switchport access vlan 101
Switch(config-if)#description keBekasi
Switch(config-if)#exit

Switch(config)#exit



- Cara Melihat Vlan Yang Sudah Kita Buat

Switch#show vlan brief

VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Fa0/11, Fa0/12, Fa0/13, Fa0/14
Fa0/15, Fa0/16, Fa0/17, Fa0/18
Fa0/19, Fa0/20, Fa0/21, Fa0/22
Fa0/23, Fa0/24
101 vlan101-keBekasi active Fa0/2, Fa0/3, Fa0/4
102 vlan102-keJakarta active Fa0/5, Fa0/6, Fa0/7
103 vlan103-keBogorr active Fa0/8, Fa0/9, Fa0/10
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active

1005 trnet-default active  


- Cara Membuat Trunk ke Router Misalnya Di Switch Yang Arah Router Di Sambungkan Ke Arah      Port 1

Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface fa 0/1
Switch(config-if)#switchport mode trunk

Switch(config-if)#exit


- Cara Kita Konfigurasi Vlan 101 Di Router Dan Ip Address Yang Mengarah ke Vlan 101 Tersebut

Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#interface fa0/1
Router(config-if)#no shutdown

Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

%LINK-5-CHANGED: Interface FastEthernet0/1.101, changed state to up


%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1.101, changed state to up\

- Kita Tes Memberikan IP Adress di IT 192.168.1.3 gateway 192.168.1.1 255.255.255.0 Dan Kita Ping